Go Down

Topic: Simple tones on a pcb piezo (Read 847 times) previous topic - next topic


Would this make some soft tones with the TONE() function driven directly off a I/O pin with a small resistor?
...it says 12volts, but it should still make some noise on 5 shouldn't it, just not too loud?


just try it, too low voltage will certainly not blow the thing
Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

WilliamK Govinda

I was driving audio directly to a headphone ear-bud without a resistor, it still works. I only added a resistor later to make the circuit better. ;-) On my better headphones I still get a good volume, but it doesn't blow the thing up.


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131