Go Down

Topic: Controlling lots of LEDs (Read 623 times) previous topic - next topic


I need to control 25 LEDs with my arduino uno individually. If there were 25 different pins then I could just hook up one to each pin, but that is not the case for me. What is the best way to do this?


You should consider using a shift register. Here is a tutorial:


The Gadget Shield: accelerometer, RGB LED, IR transmit/receive, speaker, microphone, light sensor, potentiometer, pushbuttons


.. or the more expensive, but less soldering solution of using an Arduino Mega.

More pins than you can shake a stick at.
I write books about Arduino and Electronics: http://simonmonk.org

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131