Pages: [1]   Go Down
Author Topic: Ability to serial communicate data over single wire, and change direction  (Read 1648 times)
0 Members and 1 Guest are viewing this topic.
Canton, Connecticut, United States, Planet Earth, SOL Galaxy, 3rd star on the left.
Offline Offline
Jr. Member
**
Karma: 0
Posts: 74
To Infinity, And BEYOND!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

There needs to be a way to do the following:

(a) assign ANY pin (digital 0 to 13, or even the analog pins) as a serial I/O port. Not separate RX/TX pins, 1 SINGLE RX-TX line, that can be
changed on the fly. (such as the ability to change a digital line from output to input, as done with the parallax PING))) range finder

(b) Ability to change type on ALL I/O pins, to Digital, PWM, Analog, Serial data, or even I2C.  Not limit them to specific duty.

the IDE is just a converter from the C++ derivative, to native machine code for the ATMel chips, just as the Parallax PBASIC compiler is just that, a compiler, that converts the written PBASIC program to the native machine level code of the chip. Not locking itself down to "Do Only This" specific tasks.  (unleash up to 18 digital I/O's, or serial devices, or analog monitors, or several I2C devices.

Logged

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 361
Posts: 17294
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

It depends on the performance one requires. All you asked for can be done using software 'bit bang' emulation of serial, I2C, PWM. But if you want or need maximum performance then you would need to take advantage of the built in hardware peripherals in the AVR chip and so you have to deal with dedicated pins for certain functions and work with the hardware features as they were designed.

 So off you go designing software functions to work as you want.

Lefty
« Last Edit: April 26, 2011, 10:17:45 pm by retrolefty » Logged

Grand Blanc, MI, USA
Offline Offline
Faraday Member
**
Karma: 95
Posts: 4084
CODE is a mass noun and should not be used in the plural or with an indefinite article.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Certain functions, including PWM, A/D conversion, I2C, SPI, serial are only implemented for certain pins by the MCU hardware.  Some of these could be implemented on other pins with software bit-banging (e.g. SoftSerial).

But I'm curious.  Why is this needed?  The single RX/TX line concept, not sure I'm familiar with it, is there some sort of standard for it?

I2C is a bus, so while I can certainly conceive of scenarios that require multiple busses, in general, I2C can address multiple devices on the bus.
Logged

MCP79411/12 RTC ... "One Million Ohms" ATtiny kit ... available at http://www.tindie.com/stores/JChristensen/

Pages: [1]   Go Up
Jump to: