Go Down

Topic: SIM300, not in sync/protocol error (Read 997 times) previous topic - next topic


Hi all:
I'm using SIM300 board and connected to my computer with RS232 USB to serial converter. The drivers for converter was successfully installed and I got a new COM4 port on my computer. When I tried to upload my code to the board, I just got error message:

avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect-0x14, resp=0x51

I noticed that there are lots of types of boards on the tool menu, but which should I choose? And how can I upload my code to the board?


Do you meant the SIM300-EVB Evaluation Board from Simcom?  That's not an Arduino.
Send Bitcoin tips to: 1G2qoGwMRXx8az71DVP1E81jShxtbSh5Hp

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131