Pages: [1]   Go Down
Author Topic: Arduino ISP Shields  (Read 1881 times)
0 Members and 1 Guest are viewing this topic.
UK
Offline Offline
God Member
*****
Karma: 0
Posts: 534
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Im really starting to get into the modular aspect of the arduino and shields, (after quite a while of not really being that into shields, and to a point resenting the far from standard pin pitch that meant etching your own PCBs rather then using strip board!)

But now I can afford 3rd party shields, and etch my own boards shield have really grown on me as....and i get it now!

Was reading the isp guide http://arduino.cc/en/Tutorial/ArduinoISP and Iv seen the ISP shield that turns your arduino into a standard  6-pin ribbon cable ISP, but was wondering if there were any nice open source single sided one with a dip fitted to the shield for programming of ATmega168/328 chips, or even other smaller tiny chips? 
Logged

Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 208
Posts: 8849
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

If you are going to be custom programming some ATmega chips you may want to get the HV Rescue Shield 2 from MightyOhm.com.  It allows you to re-set the fuses on almost any AVR DIP processor (28 pin, 20 pin and 8 pin).  It uses high-voltage parallel programming so it doesn't need the AVR chip to have a valid clock.  Even if serial programming has been accidentally disabled the HVRS2 can reset the chip to factory settings.

An $13 ISP Shield from Evil Mad Science:
http://evilmadscience.com/productsmenu/tinykitlist/253
It looks like it only supports28-pin ATmega8/168/328 processors.

$3 for the bare board:
http://evilmadscience.com/productsmenu/tinykitlist/254
Logged

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Pages: [1]   Go Up
Jump to: