Go Down

Topic: Driving a single Nixie tube (Read 801 times) previous topic - next topic

n00b

Hey guys (sorry if this is in the wrong place, not being a LED.)

I was wondering if I could get some info on driving a single Nixie tube with a Arduino.

Iv got a box of 7441, some Nixies and basically want to be able to display  0-9 depending on the resistance of a pot. 

johnwasser

I think you apply +170v to the anode and ground one of the cathodes through a resistor and the 7441.
Send Bitcoin tips to: 1G2qoGwMRXx8az71DVP1E81jShxtbSh5Hp

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy