Go Down

Topic: Populating a prototype shield (Read 614 times) previous topic - next topic

tastewar

Ugh! What a pain. I had my circuit prototyped (basically a MAX233 to an RJ-11 socket) on a breadboard, but wanted to turn it into something more "permanent" so I soldered it onto a prototype shield. Not particularly fun trying to solder wires between pins on the underside of the board. Also, it's plugged into my Ethernet shield, but that doesn't work out so well because the ethernet jack is taller than the headers. Argh. I'd swap the order, except that the RJ-11 I have (mounted on a breakout board to begin with) makes the prototype shield even taller than the ethernet one!

I think that's the last time I'll do that. In the future, I'll either stick a mini-breadboard on a shield, or I'll get my own board made.
/rant

davekw7x

#1
May 17, 2011, 05:51 pm Last Edit: May 17, 2011, 07:15 pm by davekw7x Reason: 1

Ugh! What a pain....

Been there; done that...

Here's what you might try:

Get some "Shield stacking headers."  For example http://www.adafruit.com/products/85  (Other vendors sell them too.)

You can use the "stacking headers" as extenders:  Plug the Ethernet Shield into the Arduino.  Plug the "stacking headers" onto the Ethernet Shield. Then plug your prototype shield on top of the headers.

It works for me.


Regards,

Dave

tastewar


Go Up