Pages: [1]   Go Down
Author Topic: Servo: Tower Pro SG5010  (Read 1668 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 41
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello. I bought few of Tower PRO SG5010 servos and I am going to do a robotic arm. http://www.servodatabase.com/servo/towerpro/sg-5010 I need to know, how many amperes do this servo need to work fully without extra weight? Does anybody now?

I would be very grateful, for your help!

binfazen
Logged

0
Offline Offline
Tesla Member
***
Karma: 141
Posts: 9470
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

With no load on the servo, maybe 200ma to move, with no signal to move, probably only several ma, under load near stall conditions, probably well over 1a.
Logged

Consider the daffodil. And while you're doing that, I'll be over here, looking through your stuff.   smiley-cool

Offline Offline
Newbie
*
Karma: 0
Posts: 41
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thank you a lot!
Logged

Pages: [1]   Go Up
Jump to: