Pages: [1]   Go Down
Author Topic: Pressure sensor & vibration motor  (Read 778 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 26
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi guys,

I want to control the vibration motor(ROB-08449) using PWM & Pressure Sensor (SEN-09376).

I am using the analogInOut sketch to control it.

I know that both the sensor & motor need 5v so any suggests on how I could  wire it & power it.

Can I use the Vin pin as an extra power source and ground it as normal?

thanks in advance.
Logged

Global Moderator
UK
Offline Offline
Brattain Member
*****
Karma: 290
Posts: 25713
I don't think you connected the grounds, Dave.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The datasheet for the motor says 75mA - do you have a transistor to drive it?
Logged

"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

0
Offline Offline
Newbie
*
Karma: 0
Posts: 26
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

yes it is a NPN 2n2222
Logged

Pages: [1]   Go Up
Jump to: