Go Down

Topic: Errors with FTDI BASIC with pro mini 3.3v (Read 404 times) previous topic - next topic

Agent_47

I just get the same not in sync errors and protocol errors and spent a good 12 hours trying to figure this out but no luck, so know its time to ask, what is wrong my pro mini or the FTDI basic programmer. I check the serial monitor to see if it responds I don't get any response and after I used this I tried burning sketch and bootloader through my uno witch always works but neither worked saying I connected something wrong but its the same as I always had it and tried as many possibilities I can and nothing worked. My FTDI drivers are up to date and my computer says it is working fine. So I really dont know what to do anymore. Any ideas will be appreciated.
thanks

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy