Pages: [1]   Go Down
Author Topic: motor driven water pump for cooling a still  (Read 359 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 35
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi all New Bee here,

i have a temp sensor that will monitor the still temperature and will turn the pump on/off with pin 6 PWM driving a FET.

My problem, The PWM seems 25% on or fully on , nothing in between. would like so is slow then get faster, or fast then slow down , but my PWN

I my code below, it is a mix of my own and some else s i have modded
any tips?

* test.doc (31.5 KB - downloaded 11 times.)

Global Moderator
Offline Offline
Brattain Member
Karma: 309
Posts: 26488
I don't think you connected the grounds, Dave.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Is a PID really essential for maintaining temperature on something as large as a still?

"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

Pages: [1]   Go Up
Jump to: