Go Down

Topic: addition to the xbeeShield-page (Read 603 times) previous topic - next topic

sirtet

Just started with Arduino and Xbee.
On the page
http://arduino.cc/en/Main/ArduinoXbeeShield
it is stated that you need to remove the microcontroller in order to communicate directly between the pc and xbee.
On another page i found out, that an easyer way is, to pull reset to gnd permanently via a wire, for the same effect.

Should be noted on the above page i think.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy