pinMode(WIZNET_RESET_PIN, OUTPUT);digitalWrite(WIZNET_RESET_PIN, HIGH);delay(50);digitalWrite(WIZNET_RESET_PIN, LOW);delay(50);digitalWrite(WIZNET_RESET_PIN, HIGH);delay(100);pinMode(10, OUTPUT); // set the SS pin as an output (necessary!) digitalWrite(10, HIGH); // but turn off the W5100 chip![code]uint8_t r = card.init(SPI_HALF_SPEED, 4); // Use digital 4 as the SD SS line
type any character to startcard.init failedSD errorerrorCode: 1errorData: 0type any character to start
I did not conect the pins to the icsp header but I did connect pins 11,12,13 together. And yes that is the board I am using.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16