Go Down

Topic: How to connect GSM shield and Arduino Duemilanove (Read 2332 times) previous topic - next topic


Hello All,

I got a brand new GSM shield from Sparkfun and I am about starting off playing with it. I would like to know how to properly power up the shield and get it working.



Hi Emaka,

You should provide more info, this question is vague. Is it this shield - http://www.sparkfun.com/products/9607 - ??
On the sparkfun page there is below the description an "arduino link  => http://tronixstuff.wordpress.com/2011/01/19/tutorial-arduino-and-gsm-cellular-part-one/

maybe that helps,

Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)


Hello Rob,

http://www.sparkfun.com/products/9607 .... That is what I have.

Let me re-frame my question... Which pins should I connect to Arduino ?



It's a shield -- why not just plug it in and connect them all? Or are you asking what pins to use in the software? If so, the web page you pointed to tells you:

Two solder jumpers on the board allow you to select which serial pins interface with the cellular module - software (D2, D3) or hardware (D0, D1).


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131