Pages: [1]   Go Down
Author Topic: cant upload to duemilanove  (Read 401 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I cant upload to the duemilanove anymore, it worked good, but now i get the following error:
' Binary sketch size: 2556 bytes (of a 30720 byte maximum)
 avrdude: stk500_getsync(): not in sync: resp=0x00
 avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51 '

and the chip on the duemilanove is getting hot.
There isn't anything connected to the board, except the usb which is working properly. The power led is blinking and also the led connected to pin 13.
im using windows 7 64 bit.
I hope you can help me.
Grtz Joost

Offline Offline
God Member
Karma: 13
Posts: 905
Twitter: @simonmonk2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Check for any blobs of solder or anything that may have falled on the board and be shorting something.

If you have another ATmega chip, try that. Gently ease the old chip out with a knife, each end a bit at a time, so as not to break the pins off.

If you dont have one, you can buy one, but make sure it has the bootloader on it. Sparkfun sell them.


My New Arduino Book:

Pages: [1]   Go Up
Jump to: