Go Down

Topic: I can't burn bootloader on microcontroller. (Read 893 times) previous topic - next topic

hibari

I wire up Duemilanove compatible board and the microcontroller as shown on the following page.

   http://arduino.cc/en/Tutorial/ArduinoToBreadboard

But, I can't burn. The following message appear. What should I do?

   stk500_getsync(); not in sync:respo=0x15

PC : Windows7
IDE : Arduino IDE 0022
target CPU : ATMEGA328P-PU
host Arduino : DFRduino (Duemilanove compatible)

Coding Badly


Those instructions are missing a step...

1.5 Disable auto-reset.

There are details here...

http://www.arduino.cc/playground/Main/DisablingAutoResetOnSerialConnection

hibari

Thank you, Mr.Coding Badly.
Sometime I can  burn the bootloader,other time I can not with same bread board. I think it is problem of the bread board. By the way, when I can not burn, the following message is showed. Does anyone have advice?

avrdude: Expected signature for ATMEGA328P is 1E 95 0F.
              Double check chip, or use -F to override the check.?

Coding Badly

Quote
Does anyone have advice?


Yes.  Post the entire error message.

hibari

avrdude: Expected signature for ATMEGA328P is 1E 95 0F
              Double check chip, or use -F to override the check.?


This is the error message. I can't burn the bootloader to the microcontroller with Arduino IDE.

BrainBooster

This means that avrdude cannot recognize the mcu or can't correctly communicate with it.
Doublecheck your connections.
but avrdude reads a different signature than the expected or it doesn't read any signature?

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy