Go Down

Topic: SerLCD Troubles (Read 521 times) previous topic - next topic

I just recently got an Arduino Uno, the Can-bus Shield, a SerLCD backpack from sparkfun, and a 20x4 LCD screen

I just went through the update of making sure that the latest USB firmware was installed on the Uno.  I used the tutorial that had me go into DFU mode, and use Flip.  That install went without a hitch.

My biggest issue is trying to install the SerLCD hex file.  Here is what I tried:

Quote

C:\Users\core2quad\Desktop\uno_programming_with_avrdude>avrdude -p m328p -c arduino -P COM10 -b 115200 -U flash:w:serlcd.hex

avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.01s

avrdude: Device signature = 0x1e950f
avrdude: NOTE: FLASH memory has been specified, an erase cycle will be performed
         To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: reading input file "serlcd.hex"
avrdude: input file serlcd.hex auto detected as Intel Hex
avrdude: writing flash (16400 bytes):

Writing | ################################################## | 100% 2.09s

avrdude: 16400 bytes of flash written
avrdude: verifying flash memory against serlcd.hex:
avrdude: load data flash data from input file serlcd.hex:
avrdude: input file serlcd.hex auto detected as Intel Hex
avrdude: input file serlcd.hex contains 16400 bytes
avrdude: reading on-chip flash data:

Reading | ################################################## | 100% 3.20s

avrdude: verifying ...
avrdude: verification error, first mismatch at byte 0x0980
         0xff != 0xf8
avrdude: verification error; content mismatch

avrdude: safemode: Fuses OK

avrdude done.  Thank you.



Just to try to make sure I can actually install a simple Blink test, I compiled and installed Blink via the arduino software, as well as through a hex file from avrdude.  Both worked fine.  Is there something I am missing here??

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy