Go Down

Topic: SquareWear: a new open-source wearable electronics board (Read 4099 times) previous topic - next topic


Hi, I just finished working on a controller board I built myself for wearable electronics projects. It's called SquareWear. I thought about posting it here in case someone may find it interesting. I designed it mainly as a low-cost solution for entry-level projects and wearable electronics workshops at schools. It has a built-in USB port (used for programming the microcontroller, creating USB serial communication, and charging battery), HID bootloader, power sink pins (suitable for driving high-current load), li-po charger, on-board LED and general-purpose push-button. Basically I've pictured it as a sewable microcontroller board that can get someone started right away -- no external programmer and no driver installation needed.

Here is an introduction video:


Find out more at http://www.sqrwear.com. Thanks.
DIY electronics project at http://rayshobby.net

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131