Go Down

Topic: NTC Thermistor vs LM35 (Read 7574 times) previous topic - next topic


Wanted to ask some opinions on the pro's and cons of each


Thermistors are very cheap, in the ballpark of $0.20. They're not very precise and their resistance change with temperature is non-linear, so you have to do a little "work" in your software to figure out the temperature.

Active devices like the LM35 are more expensive (>$1) but are more precise and provide a linear voltage-vs-temperature characteristic making it easier to figure out the temperature.

The Ruggeduino: compatible with Arduino UNO, 24V operation, all I/O's fused and protected


The LM35 is calibrated.  The thermistor has to be calibrated against some known-good temperature standards.
Send Bitcoin tips to: 1G2qoGwMRXx8az71DVP1E81jShxtbSh5Hp


if you want the temperature in Celcius and i have the LM35, just use this code:

Code: [Select]
tempC = analogRead(tempPin);
  tempC = (5.0 * tempC * 100.0)/1024.0;

and u'r pretty much all set,  with the NTC/PTC u'll need to make a circuit and even then you wont be able to do anything nearly as simple as this code.


cheers for the code

is there any other alternative other than a thermocouple that can read a higher temperature


you want to read above 155C ? 

you could try this:

but i dont know anything about it. i can just see the ratings.  if you need more advanced help on temperature i can refer you to the sensor forum in arduino: http://arduino.cc/forum/index.php/board,10.0.html 



looks like a good alternative

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131