Go Down

Topic: NTC Thermistor vs LM35 (Read 4272 times) previous topic - next topic

Gadget999

Wanted to ask some opinions on the pro's and cons of each


RuggedCircuits

Thermistors are very cheap, in the ballpark of $0.20. They're not very precise and their resistance change with temperature is non-linear, so you have to do a little "work" in your software to figure out the temperature.

Active devices like the LM35 are more expensive (>$1) but are more precise and provide a linear voltage-vs-temperature characteristic making it easier to figure out the temperature.

--
The Ruggeduino: compatible with Arduino UNO, 24V operation, all I/O's fused and protected

johnwasser

The LM35 is calibrated.  The thermistor has to be calibrated against some known-good temperature standards.
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

illillillill

if you want the temperature in Celcius and i have the LM35, just use this code:

Code: [Select]
tempC = analogRead(tempPin);
  tempC = (5.0 * tempC * 100.0)/1024.0;


and u'r pretty much all set,  with the NTC/PTC u'll need to make a circuit and even then you wont be able to do anything nearly as simple as this code.

Gadget999

cheers for the code

is there any other alternative other than a thermocouple that can read a higher temperature

illillillill

you want to read above 155C ? 

you could try this:
http://www.omega.com/rtd.html

but i dont know anything about it. i can just see the ratings.  if you need more advanced help on temperature i can refer you to the sensor forum in arduino: http://arduino.cc/forum/index.php/board,10.0.html 

Gadget999

ty

looks like a good alternative

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy