Go Down

Topic: Minimum pins for GLCD display (Read 1 time) previous topic - next topic

cowasaki

Well I have the 1284p chips.
I have one of the chips fitted to a breadboard.
I have an ISPtinyUSB and AVRISP mk II.
I have a firmware for the 1284p
I have the USB driver libusb-0.1.12
if I try to use AVRDUDE I get this fault:
Code: [Select]
MacbookPro:~ darren$ avrdude -v -patmega1284P -cusbtiny -Pusb -U lock:w:0x3F:m

avrdude: Version 5.10, compiled on Apr 30 2011 at 06:16:16
         Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
         Copyright (c) 2007-2009 Joerg Wunsch

         System wide configuration file is "/usr/local/etc/avrdude.conf"
         User configuration file is "/Users/darren/.avrduderc"
         User configuration file does not exist or is not a regular file, skipping

         Using Port                    : usb
         Using Programmer              : usbtiny
avrdude: error: no usb support. Please compile again with libusb installed.
avrdude: programmer operation not supported

avrdude done.  Thank you.

MacbookPro:~ darren$


I have tried to install the USB driver but have had no luck whatsoever!

I have tried to install fink in order to install the USB driver but fink seems to have installed but I cannot run it!

I am having a right nightmare trying to get this to work!

I bought a AVRISP mk II today to try and use that rather than the ISPtinyUSB that I did have and I have also downloaded AVRstudio.

It's not working though.......

olikraus

On my system i use avrdude to program Arduino Hardware and AVRs directly via AVRISP mk ii without problems.
Its a Ubuntu 10.04 LTS. I installed the avrdude package (with Synaptic).

Oliver

cowasaki


On my system i use avrdude to program Arduino Hardware and AVRs directly via AVRISP mk ii without problems.
Its a Ubuntu 10.04 LTS. I installed the avrdude package (with Synaptic).

Oliver


I am 5 minutes off publishing a complete step by step guide to using the 1284p :)

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy