Pages: [1]   Go Down
Author Topic: DIY Laminar Flow Nozzle and Arduino based Control system  (Read 2691 times)
0 Members and 1 Guest are viewing this topic.
Pakistan
Offline Offline
Sr. Member
****
Karma: 6
Posts: 356
Arduino rocks
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,
I just completed my Laminar Flow nozzle. Now making PCB for controlling the RGB Light, Cutter mechanism using temperature sensor,DIY anemometer and soil moisture sensor.



the cutter mechanism:


Anemometer:


Any Comments on the following PCB?


Programming the complete project is still a big challenge. I am here to seek all of your help.
Thanks


* LAMINAR FLOW NOZZLE CIRCUIT.jpg (104.31 KB, 971x598 - viewed 47 times.)
Logged


Pages: [1]   Go Up
Jump to: