Pages: [1]   Go Down
Author Topic: trying to make a boarduino  (Read 455 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 39
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

hi
i am trying to make a boarduino
i have already BIT BANG the IC with my other arduino and uploaded a simple blink code and it worked fine.
but when i put all in a breadboard its not working

here the pic
http://imageshack.us/photo/my-images/843/20110618003.jpg/
« Last Edit: June 19, 2011, 03:27:47 pm by crxksa » Logged

Leighton Buzzard, UK
Offline Offline
Edison Member
*
Karma: 21
Posts: 1339
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

a bit hard to see what's going on
do you have a schematic picture?

also take a look at the resistor that is probably the current limiter for the LED in the top right corner
seems to me it is connected between ground and 5 volts!
Logged

there are only 10 types of people
them that understands binary
and them that doesn't

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 361
Posts: 17263
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Have you made certain of the caps size used with the crystal, lots of people misread the value on the caps.


Lefty
Logged

Western New York, USA
Offline Offline
Faraday Member
**
Karma: 32
Posts: 4259
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The Boarduino (and all other good designs) has four 0.1uF bypass capacitors, your circuit has none.

Don't you somehow have to supply power to the input of your voltage regulator?


Don
« Last Edit: June 19, 2011, 08:48:28 pm by floresta » Logged

Pages: [1]   Go Up
Jump to: