Go Down

Topic: Police light set up in car and power. (Read 4540 times) previous topic - next topic

AltairLabs

BTW an important detail, dont forget a fuse to battery!

If your fuse block dont have a spare you can use an old style cop car black plastic fuse holder about the size of a deck of cards, made for under-hood installation, mounts with a single screw and a snap on weather cover / insulated lid.  These fuse holders show up in the flea market or tail gate section of your local ham radio rally, usually for just a buck or two.  They are resistant to weather, oil, heat, UV and are darn near unbreakable. Just unsnap the lid hose it down with WD-40, let it set a few hours then run it thru the dishwasher it will come out clean as new.  


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy