Pages: [1]   Go Down
Author Topic: Color Laserjet encoder  (Read 514 times)
0 Members and 1 Guest are viewing this topic.
Fort Worth, Texas
Offline Offline
Newbie
*
Karma: 0
Posts: 39
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'll salvaged two 3 wire laserjet encoders the other day. I've searched the Internet for their pin outs, but cannot find any information. I'd like to test one of them using a home made encoder wheel, but don't know the pin out. Does anyone on the board know anything about these? There are no identifying marks on either of these.

Thanks,
Cris
Logged

0
Offline Offline
Full Member
***
Karma: 0
Posts: 209
Office meets Adruino
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

you would look at the shematic for that printer. What model and area was it romoved from.
Logged

Phoenix, Arizona USA
Offline Offline
Faraday Member
**
Karma: 40
Posts: 5581
Where's the beer?
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

you would look at the shematic for that printer. What model and area was it romoved from.

redtank, I think copiertalk meant that as a question, in that s/he wants you to supply the information on what model the printer was, and from what area the encoder was removed from.

copiertalk has helped me in the past (IIRC) with a particular laser printer control panel that I picked up used and was unable to find the information for. In short order, I was informed of the pinout and proper communications protocol to use the LCD and buttons on the panel.

I can't guarantee that you'll get the same response, but if anyone had the information, copiertalk would be my first contact...

Good luck!

smiley
Logged

I will not respond to Arduino help PM's from random forum users; if you have such a question, start a new topic thread.

Fort Worth, Texas
Offline Offline
Newbie
*
Karma: 0
Posts: 39
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thank you all for the replies. I ended up doing some homework with my DMM on the leads coming out of the sensor trying to establish the anode, cathode and output. Upon testing the sensor with my Gator +, I was able to figure out that these little gems are not going to answer to my dreams. I just need to bite the bullet and spend some money on a quadrature output encoder.

Cris
Logged

Pages: [1]   Go Up
Jump to: