Pages: [1]   Go Down
Author Topic: loading sketches via Bluesmirf??  (Read 760 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
**
Karma: 0
Posts: 62
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I want to remove my FT232R USB programmer from my board and wondered if I can use my bluetooth module to program it instead. Is it possible? The only thing I can see that would be a problem is there isnt a DTR connection on it.... Is there some other way around this? With the FT232R you need a .1uF cap between the DTR and the 1st Arduino pin (RESET, PC6).... but how to do this with a Bluesmirf, I wonder.......

any ideas?
Logged

Pages: [1]   Go Up
Jump to: