Go Down

Topic: +12v into +5v on arduino uno (Read 550 times) previous topic - next topic

So… like a moron I accidentally plugged +12v into the 5v in on my uno.  Now for some reason it doesn't seem to work, go figure.  My question is, does anyone have a clue as to what I fried so I can replace it, or is the only repair a hammer smack and a trash can?

retrolefty

Quote
or is the only repair a hammer smack and a trash can?


That is the case I'm afraid. It would have burned out both processors on the board and perhaps several other components. Being some of the components are SMD devices and not easily unsoldered/soldered by the inexperienced and any commercial repair service would charge more for labor and parts then a replacement board is worth. I would chalk it up to a lesson learned and go get a new board.

Lefty

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy