Pages: 1 [2]   Go Down
Author Topic: ServoDecode - The decoder is NOT_SYNCHED  (Read 917 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 18
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

IT WORKS!
The receiver was only connected to the arduino with ground and ppm, but upon adding 5v in to the receiver things started working. It only works with the 5v in and with the ppm signal from pin 11 on the flip flop and not pin 3 which is weird as they are both clock pins.
Thanks a million for your amazing help AWOL!
Arthur
Logged

Global Moderator
UK
Offline Offline
Brattain Member
*****
Karma: 302
Posts: 26290
I don't think you connected the grounds, Dave.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Are you saying that the receiver wasn't powered at all before?
Logged

"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

Offline Offline
Newbie
*
Karma: 0
Posts: 18
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

No, I followed several tutorials to get the ppm signal and they all mentioned that the only connections needed were ground and ppm, that a Vin connection should not be necessary...
Logged

Pages: 1 [2]   Go Up
Jump to: