Go Down

Topic: Smallest Arduino - help me find it... (Read 816 times) previous topic - next topic


Some time ago there was a post on the forums here of, what I think, is was the smallest Arduino.

This guy soldered the few components (crystal, capacitor, etc...) that were needed to run Arduino directly to the processor or maybe he used a pin header. Not sure...

I have been looking for that thread last night but not been able to find it. Anyone remembers the thread I talk about and can link me to it?

Thank you in advance!




Dec 08, 2009, 08:49 am Last Edit: Dec 08, 2009, 08:51 am by jds Reason: 1
Thank you very much!

I am not 100% sure if this was the one I had seen before, it seems close enough. I think the one I had seen here before didn't have the icsp header and also no reset switch.

If anyone has seen other versions, similar to this one, please post!


Five page thread here: http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1239733868/0


Dec 08, 2009, 09:27 am Last Edit: Dec 08, 2009, 09:32 am by tweakd Reason: 1
Take a look at this:


It seems in that link the chip is running on a internal clock of 8 MHz so adding a Crystal or Ceramic Resonator 16MHz may be a good addition.



Not the one I was looking for. Thanks anyway!

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131