Pages: [1]   Go Down
Author Topic: Simulink Interface Problem  (Read 535 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello World

I have problems setting up the Arduino Target in Simulink.

My setup:
Windows 7 x64; Matlab R2010b with all required Toolboxes; Arduino-0018; Arduino Duemilanove with Atmega 328p

My Problem:
The only demo that works is the "demo_arduino_pil" example. This example runs without problems.
Alle the Other Examples finish without error but there is no downloading to the Arduino Board, no flashing lights, nothing.

So, why are the other examples like the "demo_arduino_blink" example not working?????

With the Arduino Environment everything works fine!
And I already used the "mex sfunar_digitalOutput.c" to convert to x64.

There is a Post which is quite similar with my problem and i followed the steps sugested, with no success.
http://arduino.cc/forum/index.php/topic,40441.0.html

Can anybody help, please!!!!

Thanks a lot for your effort!
Cheers
Pascal
Logged

Pages: [1]   Go Up
Jump to: