Pages: [1]   Go Down
Author Topic: Suggest a Breadboard Arduino,Please!  (Read 723 times)
0 Members and 1 Guest are viewing this topic.
ਪੰਜਾਬ
Offline Offline
Edison Member
*
Karma: 12
Posts: 1603
Another year! Alone! :(
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

i want a Arduino schematic which could be loaded(Bootloader/Sketch) with the parallel port programmer that i have made.for that it should have a dedicated fully compatible [glow]ICSP[/glow] port in schematic compatible with following Parallel programmer's schematic:

http://arduino.cc/en/Hacking/ParallelProgrammer

Regards,
Nishant Sood
« Last Edit: January 17, 2011, 02:40:43 pm by Nishant_Sood » Logged

"Real Men can Accomplish  Anything"
-  Website  
- skype : nishants5  

ਫ਼ਤੇਹ ਕਰੂਂ !

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 631
Posts: 34473
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

They are all compatible with this. It is only four pins you need to connect to.
Logged

SF Bay Area (USA)
Offline Offline
Tesla Member
***
Karma: 135
Posts: 6782
Strongly opinionated, but not official!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

well, for example, the MDC "Really Bare Bones Board" (and variants thereof) does not include an ISP connector.  if you want to connect it to a programmer, you have to stick it in a breadboard and plug in wires to the appropriate pins (not that that is so difficult...)
Logged

ਪੰਜਾਬ
Offline Offline
Edison Member
*
Karma: 12
Posts: 1603
Another year! Alone! :(
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

can i directly connect the pins on the atmega168 with that of the parallel programmer ICSP one
Logged

"Real Men can Accomplish  Anything"
-  Website  
- skype : nishants5  

ਫ਼ਤੇਹ ਕਰੂਂ !

Cumming, GA
Offline Offline
Edison Member
*
Karma: 20
Posts: 1657
Ultimate DIY: Arduino
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Look at an arduino schematic for a clue.

ICSP programmers and the process is basically designed to connect directly to the AVR chip's pins.
Logged

Pages: [1]   Go Up
Jump to: