Go Down

Topic: Check Microcontroller for short circuit? (Read 2587 times) previous topic - next topic


how could i check that my microcontroller Atmega 168 is not short circuited by using the multimeter analog or digital i have both , what settings i need to make over my multimeter?
"Real Men can Accomplish  Anything"

- skype : nishants5  

ਫ਼ਤੇਹ ਕਰੁਂ!


If you do indeed have a short circuit condition it will most likely be evident by measuring the +5vdc using dc volt function on your meter. Short circuits cause voltage regulators to go into protection mode and fold back their voltage.

More detailed testing can be done if you clearly state the type of arduino board you are using and how you are powering it.



im using an UNO but tried to make a standalone arduino and to put bootloader into it, so as such i'm feeling the need to know whter its in its fine condition?
"Real Men can Accomplish  Anything"

- skype : nishants5  

ਫ਼ਤੇਹ ਕਰੁਂ!


If your MCU is short-circuited, it will be hot to the touch after you power on.

During normal operation, nothing on the MCU board (including the power regulator) should get hot. So if you use your finger to touch the components while powered on you should get a sense of whether there are any possible shorts.

This test however can not tell you whether an input pin is shorted since the current draw is very small and it wouldn't produce any heat or affect the supply voltage.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131