Pages: [1]   Go Down
Author Topic: EasyVR help!!!  (Read 1753 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 7
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi everyone, I just purchased an EasyVR from Veear and I am attempting to operate it using the Arduino Uno.  The company states that the two are compatible however ever time I attempt to connect I receive the error message "cannot detect device connected to port com3".  I did some research and found I need to have a "bridge" program that can be downloaded from the arduino site but have found no such code.  Can anyone shed some insight into my issue or direct me to this "bridge" program?  Any help would be greatly appreciated
Logged

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 331
Posts: 16523
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Must you post the same question in three different sections of this forum? It really upsets some people and sure to get fragmented answers at best. I hope you get conflicting advice from the different sections.  smiley-wink
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 7
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
Well as I am unsure as to which section would best answer my initial question

Moderator: In which case your best course of action is to ask.

Quote
Be assured that I have no intent on upsetting anybody on this forum

Moderator: In which case you will refrain from any further personal insults.


Edit: Moderator edited to remove personal insults.
« Last Edit: July 14, 2011, 07:46:48 pm by Coding Badly » Logged

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 331
Posts: 16523
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset


Edit: Moderator edited to remove personal insults.

Thank you for that, and you too have a nice day.

Moderator: I hope you have a nice day, too, retrolefty.  Coding Badly.
« Last Edit: July 14, 2011, 07:47:08 pm by Coding Badly » Logged

Pages: [1]   Go Up
Jump to: