Pages: [1]   Go Down
Author Topic: enclosure  (Read 622 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
**
Karma: 0
Posts: 61
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello has anyone had experience in using the arduino enclosures with xbee shields, which ones dont fit with the shield attached?

I have been looking at

http://www.sparkfun.com/products/10088

http://proto-pic.co.uk/products/Chameleon-Enclosure-%252d-Black.html

http://proto-pic.co.uk/products/Crib-for-Arduino-%252d-Metal-Enclosure.html

regards
Logged

0
Offline Offline
Jr. Member
**
Karma: 0
Posts: 62
Arduino rocks / OpenLCB rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

What about http://proto-pic.co.uk/products/Box-for-Arduino.html ?
Logged

Dr. David Harris
OpenLCB Dev Team

Seattle, WA
Offline Offline
Full Member
***
Karma: 0
Posts: 174
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

If you're building several Arduino/XBee devices, you might take a look at the Stalker V2 + enclosure from Seeed Studio:

http://www.seeedstudio.com/depot/seeeduino-stalker-v2-p-727.html?cPath=80
http://www.seeedstudio.com/depot/seeeduino-stalker-v2-enclosure-p-734.html?cPath=178_184

Very nice devices, RTC + SD Card + XBee socket built in, LIPO charge/interface with solar charge capability built in, shield compatible, etc.  I've purchased several and am quite happy with them.
Logged

Offline Offline
Jr. Member
**
Karma: 0
Posts: 61
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset


I did look at that one but I have the xbee shield/module with antenna, a breakout board for a ds1338 and a sensirion sht75 and an LDR to put in the box as well. If i get a plastic one its easier to make modifications and drill holes where you need them, I guess i could mod a metal one too.
Logged

Pages: [1]   Go Up
Jump to: