Go Down

Topic: enclosure (Read 796 times) previous topic - next topic

DirtGambit

Hello has anyone had experience in using the arduino enclosures with xbee shields, which ones dont fit with the shield attached?

I have been looking at

http://www.sparkfun.com/products/10088

http://proto-pic.co.uk/products/Chameleon-Enclosure-%252d-Black.html

http://proto-pic.co.uk/products/Crib-for-Arduino-%252d-Metal-Enclosure.html

regards

dpharris

What about http://proto-pic.co.uk/products/Box-for-Arduino.html ?
Dr. David Harris
OpenLCB Dev Team

buzzdavidson

If you're building several Arduino/XBee devices, you might take a look at the Stalker V2 + enclosure from Seeed Studio:

http://www.seeedstudio.com/depot/seeeduino-stalker-v2-p-727.html?cPath=80
http://www.seeedstudio.com/depot/seeeduino-stalker-v2-enclosure-p-734.html?cPath=178_184

Very nice devices, RTC + SD Card + XBee socket built in, LIPO charge/interface with solar charge capability built in, shield compatible, etc.  I've purchased several and am quite happy with them.

DirtGambit


What about http://proto-pic.co.uk/products/Box-for-Arduino.html ?



I did look at that one but I have the xbee shield/module with antenna, a breakout board for a ds1338 and a sensirion sht75 and an LDR to put in the box as well. If i get a plastic one its easier to make modifications and drill holes where you need them, I guess i could mod a metal one too.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy