Go Down

Topic: problem interfacing parallax GPS (Read 465 times) previous topic - next topic

j_verrydt

Jul 27, 2011, 10:25 pm Last Edit: Jul 28, 2011, 08:50 am by j_verrydt Reason: 1
hello,

I'm using the following code to interface the parallax GPS and added some code to display the coordinates on an lcd.(http://www.arduino.cc/playground/Tutorials/GPS)
At the beginning, it was working fine but now it always gives the same coordinates. At the serial monitor I can see there is still coming data through the serial line.
Anyone who can help me?

Thanks,

Jens

wildbill

Post your code. Some details about what you see in the serial monitor might help too.

MarkT

Perhaps it lost acquisition... Leave it to reacquire for 5mins or so in the open where it can see lots of sky
[ I won't respond to messages, use the forum please ]

Go Up