Go Down

Topic: official arduino motor shield v3.0 problems (Read 991 times) previous topic - next topic

knaresh

Hi i am a newbie to arduino and picking up fast. i just need to know how we can setup a stepper motor and a servo motor with the official arduino motor shield v3.0 shown here http://www.arduino.cc/en/Main/ArduinoMotorShield

there is very little documentation and hence i am stuck
i have a small hobby servo ( it has three output wires ) and a five pin unipolar stepper motor

sorry if this is the wrong place or anything to post such a query
any help will be appreciated



thank you

dcat917

Check out this thread, I just figured out how to do a stepper.

http://arduino.cc/forum/index.php/topic,66614.0.html

It will only do one stepper, and does not do servos at all.

Good luck

mem

you don't need a shield to run a servo, any free digital pin will work.

see the servo tutorial here: http://arduino.cc/en/Tutorial/Sweep

knaresh

THANK YOU GUYS
that was great help.....i was successful in running my servos. and yes as you said, it seems i dont need the shield for running steppers. ;) :P

thanks again

mem


... and yes as you said, it seems i dont need the shield for running steppers. ;) :P



you do need the shield for the steppers, its the servos that run without a shield.

knaresh

oops.... sorry for that....i got all mixed up here......
i meant to say that i dont need them for servos.... :P

thanks for correcting me


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy