Go Down

Topic: Problem with the card Arduino (Read 559 times) previous topic - next topic


Hello my name is maxence.
I from france and I problem with arduino

here is the error code

Binary sketch size: 1018 bytes (of a 30720 byte maximum)
C:\Documents and Settings\William\Bureau\arduino-0022\arduino-0022\hardware/tools/avr/bin/avrdude -CC:\Documents and Settings\William\Bureau\arduino-0022\arduino-0022\hardware/tools/avr/etc/avrdude.conf -v -v -v -v -patmega328p -cstk500v1 -P\\.\COM4 -b57600 -D -Uflash:w:C:\DOCUME~1\William\LOCALS~1\Temp\build7460181327798058155.tmp\Blink.cpp.hex:i

avrdude: Version 5.4-arduino, compiled on Oct 11 2007 at 19:12:32
         Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/

         System wide configuration file is "C:\Documents and Settings\William\Bureau\arduino-0022\arduino-0022\hardware/tools/avr/etc/avrdude.conf"

         Using Port            : \\.\COM4
         Using Programmer      : stk500v1
         Overriding Baud Rate  : 57600
avrdude: ser_open(): setting dtr
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: Send: Q [51]   [20]
avrdude: Recv:
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

avrdude done.  Thank you.


thank for the response

I precise that the RX and TX LED does not light 


Coding Badly

Have you worked through the troubleshooting guide?


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131