Pages: [1]   Go Down
Author Topic: uno not uploading yet my mega ok  (Read 318 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 24
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset


my new uno I am unable to upload to with the error below
yet my mega 2560 no problems.
have tested uno on another laptop and it works fine
I am using xp pro
ide 22 clean install no extras


avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51
Logged

Global Moderator
Dallas
Offline Offline
Shannon Member
*****
Karma: 176
Posts: 12283
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset


On the Tools menu, did you select the Uno serial port (which is very likely not the same serial port assigned to the Mega)?

On the Tools menu, did you select the Uno board?
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 24
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

yes set as uno and correct com port set
works on another laptop same settings same xp pro
looking at the forum i am not the only one
and still not working tday tested again
Logged

Austin, TX
Offline Offline
Faraday Member
**
Karma: 64
Posts: 6055
Baldengineer
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Does it work if you manually reset the Arduino?
Logged

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com

Pages: [1]   Go Up
Jump to: