Pages: [1]   Go Down
Author Topic: Burn Sketch option in IDE  (Read 1345 times)
0 Members and 1 Guest are viewing this topic.
United Kingdom
Offline Offline
Tesla Member
Karma: 227
Posts: 6637
Hofstadter's Law: It always takes longer than you expect, even when you take into account Hofstadter's Law.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I would like a command to burn a sketch directly to hardware. It would allow the ISP to be selected (just like the Burn Bootloader command), program the sketch into the target processor, and set the fuses. Currently, to do this I have to temporarily modify the "upload.using" line, upload the sketch, then run avrdude from a command line to set the fuses.

Formal verification of safety-critical software, software development, and electronic design and prototyping. See Please do not ask for unpaid help via PM, use the forum.

Pages: [1]   Go Up
Jump to: