Go Down

Topic: mp3 trigger+motion sensor (Read 1 time) previous topic - next topic


Hello all. First post on this forum.
I'm looking to build a simple stand-alone mp3 player with a motion sensor for an installation. From the information I gathered it seems like I could use  Arduino, an MP3 shield (DEV-10628) and a PIR sensor. Since I have no experience with Arduino, I would like to know what I should expect (hardware setup/software programming etc). If anyone has some tips or could point me to a guide/tutorial about building such a device it would be greatly appreciated.

Many thanks,


I've used this http://www.sparkfun.com/products/9715 and if your model is similar than it's really quite simple. If you can code a few lines then it's really a matter of connecting the arduino, sensor, mp3 module, and speakers together. The volume output was decent enough for my purposes, so I attached old pc speakers to the module and it worked fine.


i Am trying to do a similar project,u got any codes to share? :)

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131