Go Down

Topic: AVR parallel cable programmer programming "jig" (Read 1 time) previous topic - next topic

follower

Hi all...

Okay, so it's not directly Arduino related (I'm only using an Arduino Diecimilla for its 5V regulated power here :-) ) but I thought I'd share this:



It's a programming "jig" I created for use with a parallel cable programmer I had access to--I used a circuit schematic I found online but worked out the protoboard layout and did the soldering all by myself--so I'm kinda proud of that. :-) Worked first time too! :D

More details can be found on my page for learning about the AVR parallel programmer and constructing a programming jig.

I'm planning to use the programmer and jig to burn the bootloader onto bare ATMegas.

--Phil.

MikMo


follower

Quote
Very nice tool. You shold be proud :-)

Thanks. :-)

--Phil.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy