Pages: [1]   Go Down
Author Topic: AVR parallel cable programmer programming "jig"  (Read 1042 times)
0 Members and 1 Guest are viewing this topic.
New Zealand
Offline Offline
God Member
*****
Karma: 0
Posts: 999
Arduino pebbles
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi all...

Okay, so it's not directly Arduino related (I'm only using an Arduino Diecimilla for its 5V regulated power here :-) ) but I thought I'd share this:



It's a programming "jig" I created for use with a parallel cable programmer I had access to--I used a circuit schematic I found online but worked out the protoboard layout and did the soldering all by myself--so I'm kinda proud of that. :-) Worked first time too! smiley-grin

More details can be found on my page for learning about the AVR parallel programmer and constructing a programming jig.

I'm planning to use the programmer and jig to burn the bootloader onto bare ATMegas.

--Phil.
Logged

Copenhagen / Denmark
Offline Offline
Edison Member
*
Karma: 6
Posts: 2360
Do it !
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Very nice tool. You shold be proud :-)
Logged

New Zealand
Offline Offline
God Member
*****
Karma: 0
Posts: 999
Arduino pebbles
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
Very nice tool. You shold be proud :-)
Thanks. :-)

--Phil.
Logged

Pages: [1]   Go Up
Jump to: