Pages: [1]   Go Down
Author Topic: Voltage Regulator - I'm drawing a blank...  (Read 1012 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 21
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have a 12v input and, using the Arduino, I need a controllable voltage output between ~3v and the full 12v... Any ideas?
Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 635
Posts: 34572
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

It's not too clear what you want. If you want a voltage regulator then you won't find any linear regulators that take 12V in and put 12V out.
But you might just want a signal line that goes from 3V3 to 12V, in that case a transistor, filter and using PWM will do it for you.
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 21
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
But you might just want a signal line that goes from 3V3 to 12V, in that case a transistor, filter and using PWM will do it for you.

That sounds about right. Could you draw up a diagram for it?
Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 635
Posts: 34572
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Well you can filter before you up the voltage or filter after.
This shows the filtering before as it has the advantage is being able to use bigger resistors and smaller capacitors:-
http://www.flickr.com/photos/33177304@N03/4745203653/in/photostream
You can replace the FET with a transistor if you like, otherwise you can use any sort of N-channel FET, not just the one shown.  Where it says FAN that is where you want to place your load. The two points shown as 12V can be connected together.
Logged

Pages: [1]   Go Up
Jump to: