« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: arduino uno board regulators  (Read 412 times)
0 Members and 1 Guest are viewing this topic.
monsterfactory
italy
Offline Offline
Jr. Member
**
Karma: 0
Posts: 52
Arduino rocks
View Profile
« on: September 11, 2011, 05:23:45 am »
 Bigger Bigger Smaller Smaller Reset Reset
hello, I opened the eagle files about arduino uno, and I noticed there are two 5 volt regulators
I think only one is used when the board is produced, but why are there both on the project?
Logged

retrolefty
Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 361
Posts: 17262
Measurement changes behavior
View Profile
« Reply #1 on: September 11, 2011, 09:14:28 am »
 Bigger Bigger Smaller Smaller Reset Reset
Just to show that there are two possible regulator types that can be installed at assembly time. Allows for better flexibility/inventory control when procuring parts for building boards in batch assemblies.

Lefty
Logged

monsterfactory
italy
Offline Offline
Jr. Member
**
Karma: 0
Posts: 52
Arduino rocks
View Profile
« Reply #2 on: September 12, 2011, 12:50:45 am »
 Bigger Bigger Smaller Smaller Reset Reset
Great, thanks!
Logged

Pages: [1]   Go Up
« previous topic   next topic »
Jump to: