Pages: [1]   Go Down
Author Topic: not in sync: resp=0x30  (Read 569 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

I have recently bought an Arduino Nano v3 from a friend.

Now I am trying to upload the blink example program into it.  But I keep getting this error:

avrdude: Version 5.4-arduino, compiled on Oct 11 2007 at 19:12:32
         Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/

         System wide configuration file is "C:\Users\Steven\Zelfstudie\arduino-0022\hardware/tools/avr/etc/avrdude.conf"

         Using Port            : \\.\COM3
         Using Programmer      : stk500v1
         Overriding Baud Rate  : 57600
avrdude: ser_open(): setting dtr
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x30
avrdude: Send: Q [51]   [20]
avrdude: Recv:
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

avrdude done.  Thank you.


I am have tried it on a desktop and my laptop:

Spec:

Desktop:
windows 7
arduino nano v3

laptop:
windows vista
arduino nano v3


Things I have tried:

firewall off
different usb port(s)
installing ftdi drivers (about 3 times)
pressing the reset button before uploading
looking for solutions on forums

It would be nice if someone could help me on the topic.

Regards,
Stieve
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

selecting an other com port gives me the following error

avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 27
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Did you selected the right board ?
Open arduino IDE, go to tools>board>and select your board.
Hope it helps.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

Thanks for the responds. Yes I have selected the right board.

I contacted my friend and the told me that he just gave me an usb-cable that had the correct connectors on it.
So now we are going to check if the arduino works on his desktop while using the same usb-cable as I am using now.

I will post if this was the problem. Because frankly I think if that is not the problem, the arduino itself must be defect.

Regards,
Stieve
Logged

Pages: [1]   Go Up
Jump to: