Pages: 1 [2]   Go Down
Author Topic: Experience with Kimco or Tequipment?  (Read 1152 times)
0 Members and 1 Guest are viewing this topic.
Global Moderator
Boston area, metrowest
Online Online
Brattain Member
Karma: 437
Posts: 23662
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

That's a nice one.

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at
Arduino for Teens available at

Offline Offline
God Member
Karma: 4
Posts: 710
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think it'll work.

Now, I just need to get busy and finish project #1. (At some point, I just need to decide when I've got it doing enough stuff, or run out of pins. smiley )

... it is poor civic hygiene to install technologies that could someday
facilitate a police state. -- Bruce Schneier

Pages: 1 [2]   Go Up
Jump to: