Pages: [1]   Go Down
Author Topic: arduino mega protoshield  (Read 835 times)
0 Members and 1 Guest are viewing this topic.
France
Offline Offline
Sr. Member
****
Karma: 0
Posts: 266
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,

I've bought an arduino mega protoshield but there is something I don't understand about soldering additional wires.

Once you solder the sockets in order to plug arduino mega, the shield PCB has a layout in order to route each pin to another hole where you can then solder a wire. This is true for lateral side (pins of Analog IN and Power) and (pins of Communication and PWM)

Maybe i've missed something, once socket is soldered on the other lateral side (pins digital 22-53), there is no way to then solder a wire to a hole being routed from these pins...

Any suggestions.

Thank you, Albert
Logged

Dubuque, Iowa, USA
Offline Offline
Edison Member
*
Karma: 29
Posts: 2239
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

There are a number of different protoshields for the Mega. You'll need to link to a picture of the one you have.
Logged

France
Offline Offline
Sr. Member
****
Karma: 0
Posts: 266
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Here is one picture of it http://docs-europe.electrocomponents.com/webdocs/0db9/0900766b80db9934.pdf
Logged

Pages: [1]   Go Up
Jump to: