avrdude: stk500_recv(): programmer is not responding
The sketch is too busy talking to listen.Try this - press & hold the reset button. Start the download - when the sketch says "downloading xxxx of xxxx bytes" release the reset - this will let the bootloader sync with the IDE.
Did you use the Arduino IDE to install the bootloader?If yes, which board did you have selected?
Now that I think about it, I think I used avrdude to install it.
Did you set the "lock bits"?
If I use USBtinyISP to burn the bootloader from the IDE, does it select the .hex file to use based on the IDE:Board setting
or is there an additional dialog where you set that?
From your comments, I presume it takes care of all the fiddly-bits as well?
Yes. If you'd like the details, the mapping from menu selection to .hex file is in a file named "boards.txt".
It always has for me. Which is why I use the IDE (brain ... overloading ... on ... fiddly-bits !!!).
Nice! Now you can fiddle with the application instead of the tools!
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16