Go Down

Topic: Help with eagle (Read 1 time) previous topic - next topic

Texy

Hi guy's,
I would like to add some patch area to a design of mine like so :


Anyone help with how to do this in eagle?

TIA,
Texy

CrossRoads

Add connectors.
Search for ma03-1, mao3-2, ma04-1, mao4-2 for 3 and 4 hole examples.
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

Texy

Thank Bob. I found m03, etc, which is close, but I can't find ma0 (yet)..........


Texy

CrossRoads

It's there, I use them all the time for shield headers & jumper fields.
When you select Edit:Add, search for ma*, they should show up.
When I get home I can tell you the specific library they are in.
If you open Edit:Add and select no library, then type ma03-1 in the bottom, it should pull that one up.
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

Texy

Thanks for the tip bob. Will give it a go later. Swmbo needs attention, lol
T.

Go Up